Did you know that installing vinyl siding costs $7.50 per square foot on average?
Lots of great things about vinyl come into play when it comes to exterior home improvements. From energy efficiency to resisting mold, it’s a common choice for vinyl siding.
But you need to take steps to install vinyl effectively for long-lasting results. If you’ve been procrastinating on adding vinyl to any home exterior, we can help.
Keep reading on how to install vinyl soffit step-by-step guide.
Table of Contents
Measure the Soffit Sections
To measure the soffit sections, you will need a tape measure and a pencil. Start by measuring the width of the area where you will be installing the vinyl soffit. Then, measure the height of the area from the top of the fascia board to the bottom of the wave. With these two measurements, you can determine how many soffit sections you will need to purchase.
Cut the Soffit Panels to Size
The next step is to cut your soffit installation panels to size. You’ll need to measure the length and width of the area you’re working on, then add an extra inch or two to allow for trimming.
Once you have your measurements, use a saw to cut the panels to size. If you’re working with a power saw, be sure to wear safety goggles and ear protection.
Attach the U-Channel to the Fascia Board
Next, you will need to attach the U-Channel to the fascia board. To do this, you will first need to measure and cut the U-Channel to size.
Once you have done this, you will need to pre-drill holes in the U-Channel and then use screws to attach it to the fascia board. Make sure that you use screws that are long enough to go through both the U-Channel and the fascia board.
Finish Up with Trim Pieces
To finish up the installation of the vinyl soffit, you need to apply finishing trim pieces. It has cut the trim strips to the proper length at the time of purchase, depending on the size of the soffit pieces. Before attaching the strips, make sure that the sides of the soffit panel are flush against the wall.
Using trim staples or small nails, attach the strips around the edges of the soffit panel. Some types of trim pieces come with a nail hole punch on the end, making it easier for even a novice DIYer to attach the trim. Trim the bottom edges with miter cuts after it is attached and paint the vinyl pieces if desired. Finishing trim pieces can also be added to any soffit corner or piece of the soffit that may have an exposed edge.
Even though the basics are covered here, there is so much to learn more on siding installation, like types of siding, the installation process, and the tools to use. With a little research and practice, anyone can become a vinyl siding install expert.
Follow This Guide on How to Install Vinyl Soffit
Knowing how to install vinyl soffit is good, but with the right tools and knowledge, it is possible to complete this project in just one day. Following our simple step-by-step guide will help you get the job done quickly and easily. With these tips in mind, you should have no problem getting your new vinyl soffit installed properly and enjoying its stylish look for years to come!
Are you interested in another article? Check out our blog post to learn more.
